Red Velvet Cheesecake Pops

Posted: July 21st, 2011   |   Category: Blog | Sweet Recipes

We are gearing up to do a very special dessert buffet for a very special person.  It’s an 80th birthday celebration so we are looking to include some extra special sweet treats on the table.  While scouring the web for ideas we stumbled across a fantastic recipe on the Steamy Kitchen website: Red Velvet Cheesecake Pops!  Below I have posted Jaden Hair’s recipe and pics of the creation process.  We will definitely be using some of these in the buffet that we make – stay tuned for pics…

 

red velvet cheesecake pops

NOTE: The below recipe and pictures have been copied from the Steamy Kitchen website

originally published by Jaden Hair


Ingredients
1 box red velvet cake mix
1/2 cup store-bought buttercream or cream cheese frosting (I used Betty Crocker Whipped Buttercream)
7” plain cheesecake
1-2 cups graham crackers, crumbled into small crumbs
1 bag of 10-12 oz. candy melts, your favorite color (I used Wilton Color Burst Pastels, can find at Michael’s crafts)
¼ – ½ cup of vegetable oil

Supplies
24-30 candy/cookie sticks (found at craft store)
Microwave safe bowl, at least 3-inches deep
1/2 tablespoon measuring spoon
Cookie sheet, covered in foil
Rectangular foam block or another cookie sheet covered in foil and topped with parchment paper

1. Bake the red velvet cake in according to directions on the box or your recipe. Alternatively, you can make the cake in the microwave. You will only use half the cake, so you might want to divide the batter into 2 pans (and enjoy cake for dessert!) Cool the cake. Once the cake is completely cool, crumble the cake with 2 forks or better yet, a food processor. Stir in the frosting to create a smooth cake mixture.

2. Using the measuring spoon, scoop & level out 1/2 tablespoon of cake.

3. Roll into ball and place on cookie sheet. Roll up about 24-30 cake balls. Place them in the refrigerator for 20-30 minutes.

3. And now for the messy part, when the cake balls are ready, scoop about 1/2 tablespoon of cheesecake. Flatten a little in one hand, add the red velvet cake ball on top. Mold the cheesecake around the cake ball a little. Using other hand, measure out another 1/2 to 3/4 tablespoon of cheesecake and mold around the rest of the cake ball. And if necessary, roll into a ball in the palm of your hands. (Note: this can get very messy. After every two cheesecake balls, I had to wash my hands and dry them thoroughly before going on to the next ones.)

4. Place cheesecake balls into refrigerator for 20-30 minutes.

4. Remove cheesecake balls and roll in graham cracker crumbs until entirely covered. Put cookie sheet back into the refrigerator while you prepare the candy melts.

3. While the cake balls are in the refrigerator, melt the candy melts in a microwave safe bowl according to directions on the bag. Add in 1/4 cup of the oil and whisk. Add in more oil until you get the right consistency, providing a thin, even coating for the cheesecake pops.

4. One at a time, dip a candy stick into the candy coating about a ½ inch. Then push stick into the “bottom” of your cheesecake ball. Now it’s officially a cheesecake pop. Be careful not to push the stick too far that it goes straight through the cake ball. Refrigerate cheesecake pops for 30 minutes to an hour (or overnight even).

5. Now it’s time to coat the cheesecake pop. Remelt the candy melts in the microwave. Take one pop and completely dip into the candy melt and remove quickly. I use Angie’s (aka Bakerella) from her book Cake Pops method of spinning the lollpop stick and tapping your wrist to remove the excess candy melt. Once this is done, put onto second cookie sheet covered in parchment paper on its top or place into rectangular foam block.

6. Refrigerate for at least 15 to 20 minutes. Always keep your cheesecake pops refrigerated until you’re ready to eat them.

Each bite has a layer of sweet candy melt, graham cracker, cheesecake and red velvet cake!

red velvet cheesecake cake pops recipe finished pops

Other Tips:

●      Use a bowl so that when the candy melts are melted, will allow for at least 3 inches of depth so you have enough room to dip your cheesecake pop.
●      I used Wilton Color Burst Pastels candy melts.
●      I did end up with more than enough cake “dough” so I rolled out 1 Tbsp cake balls to make red velvet cake pops with them.
●      Some of your graham cracker crumbs will make it into your candy melts but I didn’t notice that this was a problem. It might become a problem if you’re using chocolate or a darker color candy melt.
●      If you have any leftover candy melts, put them into a plastic zip bag for later use. You can easily cut open the bag and put the candy melts (now a block) into your electric chocolate melter or a microwave safe bowl to melt again.
●      If you don’t have a whole day to devote to this project, you can always bake the cake one day and after it cools completely, wrap it in plastic wrap. Also, you can roll the cheesecake balls on one day and dip them in candy melts the next.

1 comment for this entry:
  1. Jackie Youn SAYS:

    Great read… thanks for actually being able to use proper English and grammar in the write-up. Lately I have been reading through tons of different blogs on the topic and it just seems that so many people out there really aren’t reading enough because it seems that their lexicon and grammar are completely underdeveloped. In any case, sorry for the rant but definitely wanted to say job well done! Will be back to read up more…

Leave a Reply